We all know that space in condos can be challenging, and that makes this condo wardrobe project a must-see. Fortunately, Space Solutions has been dealing with small and unusual spaces for over 30 years, and our expertise and custom design really got a workout on this recent project.
This home office is situated in a condo between its entrance and an open kitchen. On the immediate left of the cabinetry is the original entrance closet – that closet is half-occupied by the stacked washer and dryer, with the remaining half being used for storage of cleaning products and linens. After replacing the standard builder-grade mirrored doors with our own aluminum-framed white lami glass doors, we needed to create a new closet wardrobe for the entrance. The tall cabinet section in this photo shows the wardrobe that we built, complete with drawers below. We used high-gloss white laminate for all exteriors, to match the facing of the kitchen cabinets, which are opposite this unit. The light source atop the cabinets uses LED strip lighting across the wardrobe top, facing the ceiling, to provide some ambient lighting for that corner, as the overhead fixture is a bit distant. Along the adjacent wall, we built a desk, which includes file drawers down below, and an overhead cabinet with lift-up doors. All doors and drawers on the wardrobe and cabinets feature touch-latch hardware (press the door or drawer lightly and it pops open) avoiding handles or knobs, and preserving the clean lines of the design.
The bedroom presented another challenge. There were two narrow closets on either side of the entrance to the en suite bathroom. Each was again covered with a pair of very narrow, builder-grade sliding mirrored doors. We wanted to increase the access to the wardrobes, and at the same time increase their usefulness, without affecting access to the bathroom in between. The solution: our top-hung bypass doors. Using the same door profiles and glass as our regular sliding doors, we use their top-hung hardware to create a single large panel for each closet, which slides completely to the side, in front of the bathroom door, to reveal the entire left or right closet. The top hang feature means that there is no floor track in front of the entrance to the bathroom, so you don’t have to step over it each time you enter and exit. And while it is unlikely that one would need closet access while the bathroom is in use, on the off chance that happens, the doors have the same grip on front of back so they may be opened and closed from either side.
In the second bedroom there was another small closet. In this case, we used our regular version of our sliding doors, and again replaced the existing mirrored doors. For the interior, we did something that we also did in the left hand closet of the master closet above, and built our drawers extra deep to get the most capacity out of them, but left the shelves shallower in order to make them more useful higher up. In both closets, we made the drawers with scooped fronts to again avoid handles – in this case, it was to ensure they did not interfere with the sliding doors.